Rear Crankshaft Seal

Rear crankshaft seal

To remove
1. Remove the Power train or Power train, 4WD.
2. Remove Camshaft covers, removed engine.
3. Remove Timing cover.
4. Remove Oil sump.
5. Remove the flywheel or driver plate using EN-46106 Flywheel locking attachment as a holding tool.





6. Remove the rear seal of the crankshaft.





7. Clean the parts and remove gasket residue.

To fit
1. Apply a 2 mm thick bead of 93 160 951 Flange sealant as illustrated.





2. Fit the crankshaft's rear seal using EN-47839 Fitting tool as a guide.
Tightening torque 10 Nm (7 lbf ft)





3. Fit the flywheel or driver plate using EN-46106 Flywheel locking attachment as a holding tool. Apply Thread locking adhesive, Loctite 270 to the bolts.
Tightening torque: 30 Nm + 45 degrees (22 lbf ft + 45 degrees )





4. Fit the Oil sump.
5. Fit Timing cover.
6. Fit Camshaft covers, removed engine.
7. Fit the Power train or Power train, 4WD.