Crankshaft Balancer Removal

Crankshaft Balancer Removal

Special Tools
* J 41816-A - Crankshaft Balancer Remover
* J 41816-2 - Crankshaft End Protector
* J 42386-A - Flywheel Holding Tool





Caution: Refer to Fastener Caution (Fastener Caution).

Note: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

1. Install the J 42386-A - tool and bolts.
Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation and tighten the bolts to 50 Nm (37 ft. lbs.).




2. Remove the crankshaft balancer bolt (139).




3. Use the J 41816-A - remover (1) and the J 41816-2 - protector (2) in order to remove the crankshaft balancer.




4. Remove the balancer (1).




5. Remove the J 42386-A - tool and bolts.