Installation Procedure

IMPORTANT: Failure to properly align SIR coil to steering column/steering gear system will cause the coil assembly to become damaged when the steering wheel is turned.






1. Route wiring through steering wheel and install steering wheel onto steering shaft noting orientation notch that locates steering wheel in correct position.
2. Remove yellow tab (or tape) from SIR coil assembly.
3. Install new steering wheel attachment nut.
Torque: 40 N.m (30 ft-lbs)

IMPORTANT: Always replace steering wheel attachment nut with new nut. Never reuse old nut.

4. Connect cruise control connector and install switch (if equipped). Connect horn switch connector.
5. Connect inflator module to wiring harness and install integral connector lock device.

IMPORTANT: Always replace inflator module fasteners with new fasteners. Never reuse old fasteners.

6. Install inflator module into steering wheel and torque fasteners being careful not to cross thread fasteners.
Torque: 10 N.m (89 in-lbs)

7. Snap on screw covers.
8. Enable the SIR system. (Refer to "Enabling the SIR System")