Panel Assembly - Rear Seat

PANEL ASSEMBLY - REAR SEAT - COUPE - (SEDAN SIMILAR)




1. Remove sealer.
2. Remove back glass, enter interior trim rear speakers. Drill spot welds from panel assembly-quarter inner rear, gutter assembly-rear compartment side.

NOTE: Clean all weld seams with a wire brush, prime and seal all repair areas. Apply permanent underbody sealant. It is important that proper corrosion protection processes are used on all repair areas. Prime with two-part catalyzed primer. Apply sealers and corrosion protection materials according to the paint manufacturer's recommendations.

3. Clean surface for welding and grind primer off new part at connecting points. Apply 3M(R) Weld-Thru Coating P/N 05913 (or equivalent) to all areas to he welded.
4. Measure and align. Clamp in place.
5. Use MIG to plug weld.