Power Steering Pump Wiring Harness Replacement

Power Steering Pump Wiring Harness Replacement

Removal Procedure
Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .

Important: Replace or repair wiring harnesses observing the safety regulations of electrics/electronics.



1. Disconnect the battery.




2. Remove the battery holder (1).
Remove the bolt.
3. Remove the battery.




4. Remove the battery tray.

* Cut the 2 cable ties (1).
* Remove the 3 bolts (2).

5. Remove the wiring harness, power steering mechanism ZF.




6. Overview of the wiring harness for the power steering mechanism ZF.



Installation Procedure

1. Install the wiring harness of the power steering mechanism.

Notice: Refer to Fastener Notice (Fastener Notice) .

2. Install the battery tray.
Install the 2 cable ties.

Tighten the 3 bolts to 10 N.m (89 lb in).

3. Install the battery.
4. Install the battery holder.

Tighten the bolt to 7 N.m (62 lb in).

5. Connect the battery.

* Connect the positive cable.
* Connect the negative cable.

6. For programming procedures, refer to Control Module References (Programming and Relearning) .