Rear Stabilizer Bar

SUSPENSION: REAR STABILIZER BAR: INSPECTION

1. INSPECT REAR STABILIZER BAR





(a) Before installing the nut, flip the ball joint stud back and forth 5 times as shown in the illustration.

(b) Using a torque wrench, continuously turn the nut for 2 to 4 seconds per turn, and take the torque reading on the fifth turn.

Standard turning torque - Torque : 1.0 Nm (10 kgf-cm, 8.7 in-lb for less)

NOTICE:

* Make sure that neither unusual drag nor rattle occurs during the rotation.

* Make sure that neither crack nor grease leakage exists on the dust cover.

* Make sure that the stabilizer link LH is not deformed.