Clearance Inspection
Stop Light SwitchINSPECTION
1) If the stop light switch does not operate properly (or if it does not stop at the specified position), replace with a new one.
Specified position:
L 2 mm (0.079 inch)
2) Measure the clearance between threaded end of stop light switch and stopper.
CAUTION: Be careful not to rotate the stop light switch.
Stop light switch clearance:
A 0.3 mm (0.012 inch)
3) If it is not within specified value, adjust it by adjusting the position of stop light switch.
CAUTION: Be careful not to rotate the stop light switch.