Rear

Rear Brake Pad

REMOVAL
1) Lift up the vehicle, and then remove the rear wheels.
2) Remove the brake hose bracket.





3) Remove the caliper bolt.





4) Raise the caliper body and support it.

NOTE: Do not disconnect the brake hose from the caliper body.

5) Remove the pad.





INSTALLATION
1) Apply a thin coat of Molykote M7439 (Part No. K0770YA000) to the pad clip.





2) Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the contact surface between the pad and shim.





3) Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to both surfaces of pad inner shim.





4) Install the pad to support.
5) Install the caliper body to the support.
Tightening torque: 27 N-m (2.8 kgf-m, 19.9 ft-lb)
6) Install the brake hose bracket.
Tightening torque: 33 N-m (3.4 kgf-m, 24.3 ft-lb)

INSPECTION
Check thickness A of the pad.








NOTE:
^ Always replace the pads on both sides as a set.
^ Replace pad clips if they are twisted or worn.
^ A wear indicator is installed on the inner disc brake pad. If the pad is worn to the limit, the end of wear indicator contacts disc rotor, and a squeaking sound is heard as the wheel rotates. If the sound is heard, replace the pad.
^ Replace the pad if there is oil or grease on it.