Reading and Clearing Diagnostic Trouble Codes

Read Diagnostic Trouble Code(DTC)

OPERATION
1) On the [Main Menu] display screen, select the (Each System Check).
2) On the [System Selection Menu], select the (Brake Control System).
3) Click the [OK] button after the (VDC) is displayed.
4) On the [Brake Control Diagnosis] display screen, select the (Diagnostic Code(s) Display).
5) Record DTCs and data.

NOTE:
- For detailed operation procedure, refer to the "PC application help for Subaru Select Monitor".
- For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)".
- DTCs are displayed up to three in detected order.





Inspection Mode

PROCEDURE
Reproduce the malfunction occurrence condition as much as possible.

Drive the vehicle at least ten minutes.

NOTE:
Make sure the vehicle is not dragged to one side under usual driving condition.

Clear Memory Mode

OPERATION
1) On the [Main Menu] display screen, select the (Each System Check).
2) On the [System Selection Menu], select the (Brake Control System).
3) Click the [OK] button after the (VDC) is displayed.
4) On the [Brake Control Diagnosis] display screen, select the (Clearing Memory).
5) When the "Clear Memory?" is shown on the screen, click the "YES" button.
6) When "Done" and "Turn off the ignition switch" is shown on the display screen, turn the ignition switch to OFF.

NOTE:
For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".