Installation

INSTALLATION

1) Align the cutout portion at serrated section of the column shaft and yoke, then install the universal joint into column shaft.
2) Install the universal joint to the serrations of gearbox assembly by matching alignment marks.
3) Tighten the bolt.

Tightening torque:
24 N-m (2.4 kgf-m, 17.7 ft-lb)

CAUTION:
Excessively large tightening torque of universal joint bolts may lead to heavy steering wheel operation.

Clearance between coupling of universal joint to AT level gauge:
10 mm (0.39 in) or more

4) Align the center position of the roll connector.
5) Install the steering wheel.