Installation

Front Arm

INSTALLATION
1) Using new self-locking nuts, temporary tighten the front arm.
2) Install the ball joint into housing.

CAUTION:
Before tightening, make sure the lower side of housing and stepped section of ball joint are in contact.





3) Install the stabilizer link.
Tightening torque:
60 Nm (6.1 kgf-m, 44.3 ft-lb)
4) Install the front wheels.
5) Unload the vehicle from lift, and tighten the bolt which secures the front arm to cradle with wheels in full contact with the ground and the vehicle at curb weight.
Tightening torque:
Front bushing side
95 Nm (9.7 kgf-m, 70.1 ft-lb)
Rear bushing side
140 Nm (14.3 kgf-m, 103.3 ft-lb)
6) Inspect the wheel alignment and adjust if necessary.