Replacement

Rear Differential Mount Bushing

REPLACEMENT
1) Remove the rear differential.
2) Remove the rear differential mount bushing using ST1 - 7.
1) From the SPECIAL TOOL ASSY (41399FG000), select the tool to be used for removal.
2) Apply grease to the threaded portion on the shaft of ST1 and the bearing of ST4.
3) Set the STs as shown in the illustration and tighten the ring of ST5 by hand until it stops.
4) Secure the edge of the shaft of ST1 with a spanner, and tighten the nut of ST2 until the rear differential mount bushing comes out of the sub frame.

CAUTION:
Turning the shaft of ST1 may loosen the ST5 and damage a ST. Be sure to secure the ST1.

ST1 41399FG090 SPECIAL TOOL SHAFT
ST2 41399FG070 SPECIAL TOOL NUT
ST3 41399FG050 SPECIAL TOOL SLEEVE
ST4 41399FG080 SPECIAL TOOL BEARING
ST5 41399FG060 SPECIAL TOOL RING
ST6 41399FG010 SPECIAL TOOL A
ST7 41399FG030 SPECIAL TOOL C





3) Install the rear differential mount bushing using ST1 - 7.
1) From the SPECIAL TOOL ASSY (41399FG000), select the tool to be used for installation.
2) Set the STs as shown in the illustration and tighten the ring of ST5 by hand until it stops.

CAUTION:
Be careful not to install the ST7 in a wrong direction.

3) Secure the edge of the shaft of ST1 with a spanner, tighten the nut of ST2, and press-fit the ST6 until it contacts the end face of sub frame.

CAUTION:
^ Turning the shaft of ST1 may loosen the ST5 and damage a ST. Be sure to secure the ST1.
^ Be careful not to damage a ST by tightening the nut of ST2 further after the ST6 contacts the end face of sub frame.

ST1 41399FG090 SPECIAL TOOL SHAFT
ST2 41399FG070 SPECIAL TOOL NUT
ST3 41399FG050 SPECIAL TOOL SLEEVE
ST4 41399FG080 SPECIAL TOOL BEARING
ST5 41399FG060 SPECIAL TOOL RING
ST6 41399FG020 SPECIAL TOOL B
ST7 41399FG040 SPECIAL TOOL D





4) Install the rear differential.