Installation

Oil Pump

INSTALLATION

1) Install the oil pump to bracket.








2) Install the power steering pump bracket.





3) After installing the oil pump, fill the oil pump with fluid while rotating the pulley by hand and perform air bleeding from the oil pump.

CAUTION:
Always fill the oil pump with the fluid to prevent abnormal noise and seizure of the oil pump.

4) Connect the pressure hose and suction hose.

Tightening torque:

Eye bolt
40 Nm (4.1 kgf-m, 29.5 ft-lb)

CAUTION:
Be careful not to twist hoses. Twisted hoses may contact other parts.





5) Connect the connector to the power steering oil pressure switch.
6) Install the tensioner adjuster.
7) Install the V-belts.
8) Install the pulley belt cover.
9) Connect the ground cable to battery.
10) Fill with specified power steering fluid.

CAUTION:
Never start the engine before filling with fluid; otherwise the vane pump may become seized.