Roof Spoiler

Roof Spoiler

Roof Spoiler:

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the rear gate trim.
3. Disconnect the connector of high-mounted stop light and the washer hose of rear washer.
4. Remove the bolts and nuts.







5. Remove the clips, and remove the roof spoiler.







INSTALLATION

CAUTION:
- Improper installing may cause the water leakage, make sure the harness grommet is installed securely.
- Check that there is no foreign matter in roof spoiler between the high-mounted stop light harness or washer hose, it may cause washer defective and improper installation of spoiler. Install each part in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)