Curtain Airbag Module

Curtain Airbag Module

REMOVAL

CAUTION: Refer to "CAUTION" of "General Description" before handling the airbag module. Caution

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
3. Remove the rear quarter trim.
4. Disconnect the curtain airbag module connector.
- 5 door model






- 4 door model






5. Remove the roof trim.
6. Remove the airbag guide from the front pillar.






7. Remove the bolt, and remove the curtain airbag module.

CAUTION:
- Be careful not to damage the curtain airbag module during removal.
- Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.

- 5 door model






- 4 door model






INSTALLATION

CAUTION:
- Refer to "CAUTION" of "General Description" before handling the airbag module. Caution
- When installing the curtain airbag module, install a specified part at specified place.
- Be careful not to damage the curtain airbag module during installation.
- Be careful not to damage the curtain airbag module during installation.
- Never open the curtain airbag module before activation. Never reuse the deployed curtain airbag module.
- Make sure that there are no foreign matter on airbag module.

Install each part in the reverse order of removal.

Tightening torque: 7.5 N.m (0.76 kgf.m, 5.5 ft.lb)