Hydraulic Hose: Service and Repair
Clutch Pipe and HoseREMOVAL
1) Remove the air intake chamber.
2) Drain the clutch fluid.
3) Disconnect the clutch pipe from the clutch hose and master cylinder.
4) Pull out the clamp, then disconnect the clutch hose from the bracket.
5) Remove the hose from operating cylinder.
6) Remove the bracket.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Bleed air from the clutch fluid.
Tightening torque:
T1: 15 Nm (1.5 kgf-m, 11.1 ft-lb)
T2: 18 Nm (1.8 kgf-m, 13.3 ft-lb)
T3: 25 Nm (2.5 kgf-m, 18.4 ft-lb)
INSPECTION
Check the pipes and hoses for breaks and damage. Check joints for fluid leakage. If crack, breakage or damage is found, repair or replace the faulty pipe or hose.