Glove Compartment: Service and Repair

Glove Box

REMOVAL

NOTE: Refer to "Security and Locks" section for key cylinder replacement.

1. Remove the pocket assembly.
1. Attach the protective tape (a) to the panel center LWR.
2. Remove the damper COMPL - pocket.
3. Release the stoppers and remove the pocket assembly by pulling it toward you.







2. Remove the back panel - pocket.
1. Remove the clips, and remove the cover - instrument panel side RH.

NOTE: Remove the cover - instrument panel side RH by using a plastic remover.

2. Release the clips, and remove the ornament - panel assembly passenger.







NOTE: To facilitate the removal, push the clip of the ornament - panel assembly passenger from the backside.


3. Remove the screws, claws and harness clamp, then remove the back panel - pocket.







4. Disconnect the glove box light LED connector.

INSTALLATION

Install each part in the reverse order of removal.