Operation

Multi-function Display (MFD) System

OPERATION

DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY)
The settings of the multi-function display can be changed by performing the following procedures to display the diagnostic mode.

CAUTION:
- Perform the work with IG-ON while charging the battery.
- While performing the work, close the front hood and all doors, and do not operate any electrical parts.

1. Procedure

CAUTION: Perform the steps described in (2) through (4) within 10 seconds.

1. Within 3 seconds after turning the IG-ON, turn the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD).
2. While keeping the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD) position, press the i/SET switch three times.
3. Turn the lighting switch to OFF, and press the i/SET switch three times.
4. Turn the lighting switch to Switch 1 (TAIL) or Switch 2 (HEAD) position again, press the i/SET switch three times.

NOTE:
- Except for the demonstration display setting of the diagnostic mode, the display will terminate with IG-OFF or by selecting "Back" from the menu screen.
- The demonstration display setting of the diagnostic mode will terminate by starting the engine or removing the battery. Even if it becomes IG-OFF then IG-ON again, the diagnostic mode will not terminate.
- To select other menus from the demonstration display setting, terminate the diagnostic mode by starting the engine or removing the battery, then access to the diagnostic mode again.

2. Display menu
Change the display and settings from each menu.