Daytime Running Lamp Resistor: Service and Repair

Day Time Running Resistor

REMOVAL

1. Disconnect the ground cable from battery.
2. Lift up the vehicle.
3. Remove the screw and clips, and turn over the front side of the mud guard - front.






4. Remove the resistor assembly - daytime running light.

CAUTION: The resistor may become hot. Be careful not to burn yourself when removing it.

1. Disconnect the connector.
2. Remove the bolts, then remove the resistor assembly - daytime running light.






INSTALLATION

Install each part in the reverse order of removal.

Tightening torque:
Resistor assembly - daytime running light: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)