Headlamp: Adjustments

Headlight Assembly

ADJUSTMENT

HEADLIGHT BEAM ADJUSTMENT

CAUTION:
- Turn off the light before adjusting the beam level of the light assembly - head. If it is necessary to inspect the beam level, do not keep the light on for two minutes or more.
- When blocking the light that come from outside, use a closure plate or the like.
Do not apply tape to the lens or cover it with a cloth. It may raise the temperature in the light and cause deformation/bubble formations of the plastic lens.

1. Before checking the beam level of the light assembly - head, be sure of the following:
- The area around the light assembly - head has not sustained any scratches, damage or other type of deformation.
- Vehicle is parked on a level surface.
- The inflation pressure of tires is correct.
- Vehicle's fuel tank is fully filled.

2. Bounce the vehicle several times to normalize the suspension.
3. Make certain that someone is seated in the driver's seat.
4. Measure the distance between the low beam bulb centers and the height of the bulb center.






5. Adjust the beam level of the light assembly - head.
1. Place the vehicle with the front end facing to the measurement panel, then illuminate the low beam.






2. Adjust the low beam by turning the aiming screw.