Front Washer Nozzle

Front Washer Nozzle

REMOVAL

1. Open the hood COMPL - front.
2. Remove the arm assembly - windshield wiper.
1. Remove the cover - windshield wiper arm.
2. Remove the nuts, and remove the arm assembly - windshield wiper.






3. Remove the cowl panel - side.
1. Remove the clips.
2. Release the claws, and then remove the cowl panel - side.

CAUTION: Pulling with excessive force may damage the cowl panel - side. If it is difficult to remove, use a plastic remover or equivalent tool.






4. Remove the cowl panel assembly.
1. Disconnect the hose - windshield washer.
2. Remove clips (A).
3. Check the direction of the clip (B), and push the claws from both sides to remove it.

CAUTION: When removing the clip (B), push the claw of the clip from both sides.
Be careful because the clips (B) can be damaged if you pull unnecessarily hard on them.

4. Remove the cowl panel assembly by pulling it out towards the front of the vehicle.






5. Disconnect the hose - windshield washer.






6. Remove the nozzle - windshield washer.
1. Push the claw using a flat tip screwdriver, etc.
2. When the nozzle - windshield washer lifts up, pull out the nozzle - windshield washer using a clip remover, etc.
3. Disconnect the hose - windshield washer, and remove the nozzle - windshield washer.






INSTALLATION

1. Install each part in the reverse order of removal.

FRONT WIPER
Tightening torque:
T1: 6 N.m (0.61 kgf-m, 4.4 ft-lb)
T2: 5.5 N.m (0.56 kgf-m, 4.1 ft-lb)
T3: 22 N.m (2.24 kgf-m, 16.2 ft-lb)
T4: 8.5 N.m (0.87 kgf-m, 6.3 ft-lb) by 115�.

2. Adjust the position of the nozzle - windshield washer.