Rear Washer

Rear Washer

REMOVAL

1. Disconnect the ground cable from battery.
2. Remove the trim panel - rear gate UPR.
1. Remove the claws on the trim edge.
2. Release the claws in the center of trim, and remove the trim panel - rear gate UPR.






3. Remove the light assembly - high-mounted.
1. Remove the nut.
2. Disconnect the connector and remove the light assembly - high-mounted.






4. Remove the nozzle - rear washer.

CAUTION: Before removing, apply protective tape to the body panel and used tools not to damage the panel -rear gate.

1. Push the claw using a flat tip screwdriver, etc.
2. When the nozzle - rear washer lifts up, pull out the nozzle - rear washer using a clip remover, etc.
3. Disconnect the hose - rear washer, and remove the nozzle - rear washer.






INSTALLATION

1. Install each part in the reverse order of removal.

Tightening torque:
Light assembly - high-mounted: 4.5 N.m (0.46 kgf-m, 3.3 ft-lb)

2. Check the nozzle - rear washer position.