Rear Wiper Arm

Rear Wiper Arm

REMOVAL

1. Pull up the cover - rear wiper arm.
2. Remove the nut, and remove the arm assembly - rear wiper.






INSTALLATION

1. Install in the reverse order of removal.
2. Operate the rear wiper once.
3. Align the blade assembly - rear wiper with the marking on the glass, and then tighten the nut to the specified torque.






Tightening torque: 8 N.m (0.82 kgf-m, 5.9 ft-lb)

4. Operate the wiper to check whether the wiper blade aligns with the point mark. If not, perform installation over again.