Installation

Oil Pump

INSTALLATION

1) Install the bracket to the power steering oil pump.





Tightening torque:
T1: 16 Nm (1.63 kgf-m, 11.8 ft-lb)
T2: 36 Nm (3.67 kgf-m, 26.6 ft-lb)

2) Install the power steering pump bracket.

Tightening torque:
H4 model: 22 Nm (2.24 kgf-m, 16.2 ft-lb)
H6 model: 33 Nm (3.36 kgf-m, 24.3 ft-lb)

3) Connect the pressure hose (b) and suction hose (a).

CAUTION:
Be careful when installing; If the hose is twisted it may come into contact with other parts.





Tightening torque:
Eye bolt: 40 Nm (4.08 kgf-m, 29.5 ft-lb)

4) Connect the power steering pump switch to the connector.
5) After installing the oil pump, fill the oil pump with as much fluid as possible by rotating the pulley by hand.

CAUTION:
Always fill the oil pump with the fluid to prevent abnormal noise and seizure of the oil pump.

6) Install the V-belts.
7) Connect the battery ground terminal.
8) Fill with recommended power steering fluid and perform air bleeding.

CAUTION:
Never start the engine before filling with fluid; otherwise the vane pump may become seized.