Installation

Front Lateral Link

INSTALLATION

CAUTION:
^ Be sure to use a new self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

1) Before installation, inspect the following items and replace any faulty part with a new one.
^ Visually check the front lateral link for damage and deformation.
^ Visually check the bushing for abnormal cracks, fatigue or damage.
^ Visually check the dust cover on the ball joint for abnormal cracks, fatigue or damage.
2) Install each part in the reverse order of removal.

Tightening torque:
Front lateral link - sub frame: 120 Nm (12.24 kgf-m, 88.5 ft-lb)
Front lateral link - rear axle housing: 60 Nm (6.12 kgf-m, 44.3 ft-lb)

3) Inspect the wheel alignment and adjust if necessary. Front Suspension