Front Washer Nozzle

Front Washer Nozzle

REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the front wiper arm assembly.

CAUTION: Follow the steps below when standing up the wiper arm. Not following the steps may cause contacting of wiper arms and damages of wiper arms.

1. Stand up the driver's side wiper arm.
2. Stand up the passenger's side wiper arm.
Fold the wiper arms in the reverse order.

1. Remove the cap.
2. Remove the nuts, and remove the front wiper arm assembly.






3. Remove the cowl panel side.
1. Detach the pins of the cowl panel side.
2. Remove the cowl panel side from inside the fender panel by pulling it.

CAUTION: Applying excessive pulling force may damage the cowl panel side. If it is difficult to remove, use a plastic remover or equivalent tool.






4. Remove the cowl panel.
1. Remove clips (A).
2. Push the claw of the clip (B) from both sides to remove it.

CAUTION:
- When removing the clip (B), push the claw of the clip from both sides.
- Be careful because the clip can be damaged if you pull unnecessarily hard on them.






3. Disconnect the washer hose.






5. Remove the front washer nozzle.
1. Push the claw using a flat tip screwdriver, etc.
2. When the washer nozzle lifts up, pull out the nozzle using a clip remover, etc.
3. Disconnect the washer hose and remove the washer nozzle.






INSTALLATION

1. Install each part in the reverse order of removal.

Tightening torque:
T1: 6 N.m (0.61 kgf-m, 4.4 ft-lb)
T2: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
T3: 22 N.m (2.24 kgf-m, 16.2 ft-lb)
T4: 32.1 N.m (3.27 kgf-m, 23.7 ft-lb)

2. Adjust the washer nozzle position.