Installation

INSTALLATION

1) Place the disc cover between housing (A) and front hub unit, and tighten the four bolts.




Tightening torque:
65 Nm (6.63 kgf-m, 47.9 ft-lb)

2) Install the front drive shaft.
3) Tighten the axle nut temporarily.
4) Install the disc rotor to hub.
5) Install the disc brake caliper on the housing.

Tightening torque:
80 Nm (8.16 kgf-m, 59.0 ft-lb)

6) Install the front ABS wheel speed sensor on the housing.

Tightening torque:
7.5 Nm (0.76 kgf-m, 5.5 ft-lb)

7) While depressing the brake pedal, tighten a new axle nut to the specified torque and lock it securely.

CAUTION:
^ Do not install wheel and let it touch the ground before tightening the axle nut. Failure to follow this rule may damage the axle bearing.
^ Do not overtighten the nuts as this may damage the axle bearing.

Tightening torque:
220 Nm (22.43 kgf-m, 162.3 ft-lb)

8) After tightening the axle nut, lock it securely.





9) Install the wheel.

Tightening torque:
100 Nm (10.20 kgf-m, 73.8 ft-lb)