Installation
INSTALLATIONCAUTION:
^ Be sure to use a new flange nut and self-locking nut.
^ Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
^ Perform installation with Anti-Walk Ring (c) and stabilizer bushing (b) fitted 6 mm (6.24 in) apart.
1) Before installation, inspect the following items and replace any faulty part with a new one.
^ Check the bushing for abnormal cracks, fatigue or damage.
^ Check the stabilizer link for damage.
2) Install each part in the reverse order of removal.
Tightening torque:
Stabilizer link: 33 Nm (3.36 kgf-m, 24.3 ft-lb)
Stabilizer clamp: 38 Nm (3.87 kgf-m, 28.0 ft-lb)
3) Install the rear wheels.
Tightening torque:
120 Nm (12.24 kgf-m, 88.5 ft-lb)