Installation
INSTALLATION1) Before installation, check the following items, and replace the propeller shaft assembly as necessary.
^ Dents or cracks on the tube surface
^ Splines for deformation or abnormal wear
^ Unsmooth joint operation or abnormal noise
^ Center bearing for free play, noise or non-smooth operation.
^ Oil seals for abnormal wear or damage
^ Damaged center bearing
2) Insert the sleeve yoke into the transmission and attach center bearing to body.
Tightening torque:
52 Nm (5.3 kgf-m, 38.4 ft-lb)
3) Align the alignment marks (A), and connect the flange yoke and rear differential.
Tightening torque:
31 Nm (3.16 kgf-m, 22.9 ft-lb)
4) Check the propeller shaft with the propeller shaft installed to the vehicle. Testing and Inspection
5) Install the heat shield cover.
Tightening torque:
18 Nm (1.84 kgf-m, 13.3 ft-lb)
6) Install the center exhaust pipe and rear exhaust pipe.
7) Lower the vehicle.