Parking Brake Cable: Service and Repair
REMOVAL
1. Remove brake drum.
2. Disconnect parking brake cable from brake shoe lever.
3. Disconnect brake cable from brake back plate.
NOTE: When it is necessary to remove both right and left parking brake cable, repeat above steps 1. to 3. on right and left wheels.
4. Remove cable from parking brake lever.
5. Remove cable from vehicle body.
INSTALLATION
Install parts in reverse order of removal procedure, noting the following.
1. Install brake cable stopper ring to brake back plate securely as shown in above image.
2. Install brake cable spring and nipple end to parking brake shoe lever securely as shown.
3. Install brake shoe assembly.
4. Install brake drum installation.
5. For proper routing and secure clamping of parking brake cable, refer to above image.
6. Install cable to parking brake lever.
7. Upon completion of installation, adjust cable. Then check brake drum for dragging and brake system for proper performance. After removing vehicle from hoist, brake test should be performed.