P0011

DTC P0011/P0012

DTC Detecting Condition and Trouble Area






Circuit Diagram

Circuit Diagram:

DTC Confirmation Procedure

WARNING:
- Perform road test in a place where there is no traffic to prevent an accident.
- Road test should be performed by two persons, a driver and a tester, on a level road.

NOTE:
- Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
- Confirm that the following conditions are met in this "DTC Confirmation Procedure".
- DTC P0010, P0335 or P0340 is not detected.

1. Connect scan tool with ignition mode of keyless push start system in "OFF".
2. Warm up engine to normal operating temperature.
3. Drive vehicle for 30 sec. at throttle opening 30% or more checking the opening with scan tool.

DTC Troubleshooting

Step 1-7:

Step 8-11: