P0871
DTC P0871DTC Detecting Condition and Trouble Area
Circuit Diagram
DTC Confirmation Procedure
WARNING:
^ Perform road test in a place where there is no traffic to prevent an accident.
^ Road test should be performed by two persons, a driver and a tester, on a level road.
NOTE:
^ Be sure to troubleshoot first unexpected DTCs previously detected in "DTC Confirmation Procedure".
^ Confirm that the following conditions are met in this procedure.
- Battery voltage > 10.5 V
- 0.5 < Gear ratio < 1.0
1) Drive vehicle at 30 - 50 km/h (19 mile/h - 31 mile/h) constantly for 40 sec. or more at "D" range. (Keep throttle valve opening constantly in this step).
2) Stop vehicle.
3) Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 10 sec.
4) Push engine switch to change ignition mode to "ON".
5) Repeat Step 1) through 2) twice.
DTC Troubleshooting
