Hood Lock Member, Lamp Support Brace and Lamp Support Member Removal and Installation

Hood Lock Member, Lamp Support Brace And Lamp Support Member Removal And Installation







NOTE: Welding method and number of welding points are the same on both sides. This repair instruction shows procedure for left side.

Removal

1. Remove front fender.
2. Remove 4 bolts and remove hood lock member from vehicle body.







3. Remove 4 bolts and remove lamp support brace and lamp support member from vehicle body.







4. Drill out welding spots to separate lamp support brace and lamp support member.







Installation

NOTE: Before conducting any weld, check installation position and condition for installation part(s).

1. Attach lamp support brace and lamp support member and tighten 4 bolts tentatively.
2. Install front fender panel tentatively and adjust position.
3. Remove front fender panel.
4. Tighten 4 bolts to specified torque.







5. Conduct plug weld.







6. Install hood lock member.
7. Tighten 4 bolts to specified torque.