Fuel Supply Line: Service and Repair

Fuel Pipe Removal and Installation

Removal
1. Relieve fuel pressure in fuel feed line.
2. Remove battery, battery tray and battery bracket.
3. Remove left side main floor undercover.
4. Remove fuel pipe stopper (1) and disconnect quick joint (3) of fuel feed pipe.
5. Mark location of clamps (4) on fuel feed pipe (body side) (2), so that clamps can be reinstalled to where they were.
6. Remove clamps (4) from vehicle body, fuel feed pipe (body side) (2) and brake pipes.

CAUTION: Be careful not to bend and damage fuel feed pipe and brake pipes when removing clamp.

7. Remove fuel feed pipe (body side) (2).






Installation
1. Install clamps (1) to marked location on pipe. If clamp is deformed or broken, replace it with new one.
2. Install fuel feed pipe with pipe clamps (1) to vehicle.
3. Connect quick joint (2) of fuel feed pipe and install fuel pipe stopper (3).

NOTE: Clearance "a" between quick joint and parking cable clamp (4) should be more than 15 mm.






4. Install left side main floor undercover.
5. Install battery bracket and battery tray.
6. Install ECM and bracket.
7. Install air cleaner assembly.
8. Install battery.
9. With engine stopped, ignition mode of keyless push start system in "ON" and check for fuel leaks.