Front Seat Belt Removal and Installation

Front Seat Belt Removal And Installation

WARNING: Be sure to read Precautions on Service and Diagnosis of Seat Belt before starting to work and observe every precaution during work. Neglecting them may result in personal injury or inactivation of the seat belt pretensioner when necessary.

Removal

NOTE: Refer to Repair and Inspection Required after Accident before replacing an activated pretensioner.

1. Disconnect negative (-) cable at battery.
2. Disable air bag system. Refer to Disabling Air Bag System.
3. Remove center pillar lower trim.
4. Remove lap pretensioner connector cover (1).
5. Disconnect connector (2) from lap pretensioner (3) as shown in figure.
a. Release lock (4).
b. Disconnect connector (2).






6 Disconnect connector (1) from seat belt pretensioner (2) as shown in figure.
a. Release lock (3).
b. Disconnect connector (1).






7. Remove screw and bolts of front seat belt.
8. Remove front seat belt.

Installation
Reverse removal procedure, noting the following points.
- Check that pins (3) on body are inserted in long holes (2) on retractor pretensioner (1).






- Tighten bolts and screw of front seat belt in the numerical order to specified torque.
- Connect connector (2) to retractor pretensioner (1) as follows.
a. Connect connector (2) to retractor pretensioner with lock (3) released.
b. Press lock button (3) to lock connector securely.






- Connect connector (1) to lap pretensioner (2) as follows.
a. Connect connector (1) to retractor pretensioner with lock (3) released.
b. Press lock button (3) to lock connector securely.

- Install lap pretensioner connector cover (4).






- Enable air bag system.