CVT Fluid Check
CVT Fluid CheckCAUTION:
^ To obtain proper data from CVT performance test, check and adjust the fluid level before the test.
^ If any checking of CVT is carried out without checking and adjusting the fluid level, the checking result may show a discrepancy.
1) Check CVT fluid for deterioration referring to factors shown below.
Replace CVT fluid and also check functioning of CVT and the vehicle if any faulty conditions are found.
NOTE:
Burning smell or heavy discoloration of CVT fluid suggests that dust-size friction material particles are mixed in the fluid. In that case, replacement of CVT assembly may be required.
^ Varnish-like appearance
^ Milky or whitish appearance
^ Large amount of metal particles mixed in fluid
2) Confirm that ignition mode of keyless push start system is "OFF" and connect SUZUKI scan tool to DLC (1).
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
3) Display "Data List" mode on SUZUKI scan tool.
4) Drive vehicle so that CVT fluid temperature reaches normal operating temperature (70 - 80° C (158 - 176° F)).
NOTE:
Engine coolant temperature rises when racing engine at "P" or "N" range. But CVT fluid temperature does not rise at "P" or "N" range. Be sure to drive vehicle in order to rise CVT fluid temperature.
5) Stop vehicle with engine running and place it horizontally.
6) With select lever at "P" range, apply parking brake and block wheels.
7) Keep engine idling, depress brake pedal fully and shift select lever slowly to "D" and back to "P" position.
8) With engine idling and A/C switch turned off, pull out fluid level gauge (1), wipe it off with lint-free paper towel and put it back into place.
9) Pull out fluid level gauge (1) again and check CVT fluid level indicated on it. Lowest fluid level should be between full hot (2) and low hot (3). If it is below low hot, add specified CVT fluid up to full hot.
CVT fluid specification
: SUZUKI CVT FLUID GREEN 1 or Shell GREEN-1 V
NOTE:
^ Do not race engine while checking fluid level, even after engine start.
^ Although fluid level can be checked temporarily at room (cold) temperature of 20 - 30° C (68 - 86° F), this level check is considered to be preparation before performing level check under normal operating (hot) temperature.
^ Bringing level from low hot to full hot requires 0.6 liters (1.27 / 1.06 US / Imp. pt.).
^ If vehicle was driven under high load such as pulling trailer, fluid level should be checked about half an hour after it is stopped.
^ Check lower position of fluid on both sides of level gauge.