Diesel Data: Automotive Repair
Home >> Suzuki >> 2010 >> Kizashi AWD L4-2.4L >> Repair and Diagnosis >> Transmission and Drivetrain >> Drive Axles, Bearings and Joints >> Axle Shaft Assembly >> Service and Repair >> Removal and Replacement >> Front >> Drive Intermediate Shaft Assembly Removal and Installation

Drive Intermediate Shaft Assembly Removal and Installation

Drive Intermediate Shaft Assembly Removal and Installation

Removal
1) Drain transaxle oil.
- 6M/T model:
- CVT model:
2) Remove right side front drive shaft assembly.
3) Remove intermediate support bolts (1) and drive intermediate shaft assembly (2) from transaxle.

CAUTION:
Be careful not to damage differential side oil seal while removing the drive intermediate shaft.





Installation

CAUTION:
Be careful not to damage differential side oil seal while installing the drive intermediate shaft.

Reverse removal procedure for installation noting the following points:
^ Use new circlip.
^ Tighten intermediate support bolts (1) in numerical order as shown in figure.

1) Temporarily tighten intermediate support bolts in numerical order ("1" - "3").
2) Tighten intermediate support bolts to specified torque in numerical order ("4" - "6").

Tightening torque
Intermediate support bolt* (a): 55 Nm (5.6 kg-m, 40.5 lbf-ft)




Diesel-Data.com