Control Rod / Bushing Disassembly and Reassembly

Control Rod / Bushing Disassembly and Reassembly

Disassembly

1) Push out control rod bushing (2) by using special tool and hydraulic press (1).
Special Tool

(A): 09913-70210





Reassembly

Reverse disassembly procedure, noting the following points.

- Use special tool and hydraulic press (1) to press fit control rod bushing (2).
- Bushing should be directed as shown below and both ends of bushing collar (4) projecting from control rod should be the same in amount.

NOTE:
Any removed bushing will not fit properly if you reuse it.

Always use a new bushing.

Special Tool

(A): 09913-85210