Upper Arm and Bushing Disassembly and Reassembly

Upper Arm and Bushing Disassembly and Reassembly

Disassembly

1) Push out upper arm bushing (2) using special tool and hydraulic press (1).
Special Tool

(A): 09913-80113
(Bearing installer)

(B): 09913-70210
(Bearing installer set)





Reassembly

Reverse disassembly procedure, noting the following points.

- Use special tool and hydraulic press (1) to press fit upper arm bushing (2).
- Bushing should be directed as shown below and both ends of bushing collar (4) projecting from control rod should be the same in amount.

NOTE:
Any removed bushing will not fit properly if you reuse it.

Always use a new bushing.

Special Tool

(A): 09913-85210
(Bearing installer)