Driver Forward Impact Sensor Circuit Open

DTC B1074: Driver Forward Impact Sensor Circuit Open

Wiring Diagram

Refer to Driver Forward Impact Sensor Circuit Shorted to Ground DTC B1073: Driver Forward Impact Sensor Circuit Shorted to Ground:Except Advanced Air Bag.

DTC Detecting Condition and Trouble Area






DTC Troubleshooting



1.
Was "Air Bag Diagnostic System Check Flow" performed?
YES
Go to Step 2.
NO
Go to Air Bag Diagnostic System Check Flow:Except Advanced Air Bag.

2. Forward impact-sensor circuit check

Disconnect forward impact-sensor connector "E40".
Disconnect SDM connector "L04".
Check for proper connection to SDM connector at terminals "L04-50" and "L04-51".
Check for proper connection to forward impact-sensor connector at terminals "E40-1" and "E40-2".
Measure resistance between "L04-50" and "E40-1" terminals, between "L04-51" and "E40-2" terminals.
Special Tool

(A): 09932-76010





Is each measured resistance 1 ohms or less?
YES
Go to Step 3.
NO
Repair high resistance or open in defective circuit.

3. Forward impact-sensor circuit check

With ignition turned ON, measure voltage between "L04-50" terminal and body ground, between "L04-51" terminal and body ground.
Special Tool

(A): 09932-76010





Is each measured voltage 0 V?
YES
Replace forward impact-sensor, and recheck.
If DTC still detected, replace SDM.
NO
Repair short to power supply circuit or other circuit in defective circuit.

NOTE:

Upon completion of inspection and repair work, perform the following items.

- Reconnect all air bag system components and ensure all components are properly mounted.
- Clear DTCs referring to DTC Clearance DTC Clearance:Except Advanced Air Bag
, if any.
- Repeat Air Bag Diagnostic System Check Air Bag Diagnostic System Check:Except Advanced Air Bag
to confirm that the trouble has been corrected.