B1132

DTC B1132

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

1) Push engine switch to change ignition mode to "ON".

DTC Troubleshooting

1. Wiper interval adjustment switch power supply circuit check

Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect wiper/washer switch and "G05" connectors.
Check for proper terminal connection to wiper/washer switch and "G05" connectors.
If connections are OK, check the following points.
- Resistance between "A1" circuit and ground: infinity
- Resistance between "A1" and "A3" circuit terminals at wiper and washer switch connector: infinity

Are they in good condition?
YES -
Go to Step 2.
NO -
Repair or replace defective wire harness.

2. Wiper and washer switch check

Check wiper and washer switch. Wiper and Washer Switch Inspection

Is it in good condition?
YES -
Substitute a known-good BCM and recheck DTC.
NO -
Replace wiper and washer switch. Wiper and Washer Switch Removal and Installation