B1141

DTC B1141 / B1142

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

1) Push engine switch to change ignition mode to "ON".

DTC Troubleshooting

1. DTC check

Is DTC B1132 detected together?
YES -
Go to troubleshooting for applicable DTC.
NO -
Go to Step 2.

2. Outside air temperature sensor circuit check

Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect outside air temperature sensor and "E05" connectors.
Check for proper terminal connection to outside air temperature sensor and "E05" connectors.
If connections are OK, check the following points.
- Resistance of "A1" and "A2" circuits: less than 3 ohms
- Resistance between "A1" circuit and ground: infinity
- Resistance between "A1" and "A2" circuit terminals at outside air temperature sensor connector: infinity
- Voltage of "A1" and "A2" circuits: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition?
YES -
Go to Step 3.
NO -
Repair or replace defective wire harness.

3. Outside air temperature sensor check

Check outside air temperature sensor. Inspection

Is it in good condition?
YES -
Substitute a known-good BCM and recheck DTC.
NO -
Replace outside air temperature sensor. Removal and Installation