P0575

DTC P0575

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Troubleshooting

1. Parameter check

Connect SUZUKI scan tool to DLC with ignition mode of keyless push start system in "OFF".
Push engine switch to change ignition mode to "ON".
Check "Cruise CANCEL Switch", "Cruise RES/ACC Switch", "Cruise SET/COAST Switch" and "Cruise ON/OFF Switch" displayed on SUZUKI scan tool. Scan Tool Testing and Procedures

Are they in good condition?
YES -
Intermittent trouble.
NO -
Go to Step 2.

2. Cruise control switch circuit check

Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect "C01", "E01" and "G165" connectors.
Check for proper terminal connection to "C01", "E01" and "G165" connectors.
If connections are OK, check the following points.
- Resistance of "A1" and "A2" circuits: less than 3 ohms
- Resistance between "A1" circuit and ground: infinity
- Resistance between "A1" circuit terminal and other terminals at "G165" connector: infinity
- Resistance between "A2" circuit terminal and other terminals at "G165" connector: infinity
- Voltage of "A1" and "A2" circuits: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition?
YES -
Go to Step 3.
NO -
Repair or replace defective wire harness.

3. Cruise control switch check

Check cruise control switch Service and Repair

Is it in good condition?
YES -
Replace ECM and recheck DTC.
NO -
Replace cruise control switch.