P0962

DTC P0962 / P0963

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

P0962

NOTE:

Confirm that the following conditions are met in this procedure.

- Battery voltage > 10.5 V

1) Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.

P0963

NOTE:

- If other DTC than P0962 or P0963 is newly detected during this "DTC Confirmation Procedure", troubleshoot the newly detected DTC in first.
- Confirm that the following conditions are met in this procedure.

- Battery voltage > 10.5 V

2) Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.

DTC Troubleshooting

1.
Was "CVT System Check" performed?
YES -
Go to Step 2.
NO -
Go to CVT System Check CVT System Check.

2. Line pressure control solenoid valve drive circuit check

Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect "C142", "E19" and "E20" connectors.
Check for proper terminal connection to "C142", "E19" and "E20" connectors.
If connections are OK, check the following points.
- Resistance of "A1" circuit: less than 1 ohms
- Resistance of "A1" circuit between "C142" connector and ground: infinity
- Resistance between "A1" circuit terminal and each terminal at "C142" connector: infinity
- Voltage of "A1" circuit: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition?
YES -
Go to Step 3.
NO -
Repair or replace defective wire harness.

3. Line pressure control solenoid valve check

Check resistance of line pressure control solenoid valve. Testing and Inspection

Is it in good condition?
YES -
Substitute a known-good TCM and recheck DTC. Service and Repair
NO -
Replace line pressure control solenoid valve (valve body assembly). Service and Repair