Flywheel / Drive Plate Inspection

Flywheel / Drive Plate Inspection

Main Bearing, Crankshaft and Cylinder Block Removal and Installation

Visual Inspection

- Check ring gear of flywheel for M/T model or drive plate for CVT model, for cracking, wear or any damage.
Replace flywheel for M/T model or drive plate for CVT model if defective condition is found. Flywheel / Drive Plate Removal and Installation

Flywheel / Drive Plate Face Runout

- Check flywheel for M/T model or drive plate for CVT model for runout using dial gauge and "V" blocks.
Replace flywheel for M/T model or drive plate for CVT model if measured runout exceeds the limit. Flywheel / Drive Plate Removal and Installation

Flywheel / drive plate face runout
Limit: 0.2 mm (0.0078 in.)