Removal

PROCEDURE





1. Remove the Intake Chamber assembly.
2. Disconnect Injector connectors.
^ Disconnect the heater hose from the Intake Manifold.





^ Remove the 9 bolts. 2 nuts, 2 plate washers and Intake Manifold assembly.
3. Remove right hand engine mounting stay and water outlet.





^ Disconnect the following hoses and connectors:
- Radiator inlet hose. (1)
- Engine coolant reservoir hose. (2)
- Engine Coolant Temperature Sensor connector. (3)
- Engine Coolant Temperature Switch connector. (4)
- Ground strap connector. (5)





^ Remove the 3 bolts and right hand mounting stay.
^ Remove the wire band.
^ Disconnect the water bypass hose from the inlet housing.





^ Remove the 2 bolts, 2 nuts, 2 plate washers and water outlet.
^ Remove the 2 gaskets.
4. Remove Knock Sensors.




^ Disconnect the Knock Sensor connectors.
^ Remove the Knock Sensors.