With SV25 Series Pump

REMOVAL AND INSTALLATION OF POWER STEERING PUMP (5V25 Series)
Remove and install the parts as shown.





(MAIN POINTS OF REMOVAL AND INSTALLATION)
1. DISCONNECT AND CONNECT PRESSURE LINE
Using SST, disconnect and connect the pressure line. SST 09631-22020

HINT: When connecting, use a torque wrench with a fulcrum length of 340 mm (13.39 in.).





2. DISCONNECT TIE ROD END RH
(a) Remove the cotter pin and nut.
(b) Using SST, disconnect the tie rod end RH. SST 09610-55012





3. REMOVE DRIVE BELT
(a) Loosen the adjusting bolt and the through bolt and push the PS pump forward.
(b) Remove the drive belt.





4. REMOVE PUMP BRACKET
(a) Remove the adjusting bolt.
(b) Remove the bolt and bracket.





5. REMOVE REAR PUMP STAY
Remove the two bolts and stay.





6. REMOVE PS PUMP WITH PRESSURE TUBE
(a) Remove the through bolt
(b) Remove the PS pump from the lower side of body.