All Wheel Drive Models

CAMBER

Camber angle is not adjustable. If camber angle is not to specification, inspect and/or replace suspension components as required. Left/right error when checking should not exceed 30°.

TOE-IN

Measure distance between each wheel disc and corner of the cam bracket and confirm that both are equal. Left/right error should be less than .12 inch. If left to right error exceeds specified amount, proceed as follows:
1. If the toe-in is out of specification toward the toe-out side, lengthen the shorter arm by using the cam adjusting bolt.
2. If the toe-in is out of specification toward the toe-in side, shorten the longer arm by using the cam adjusting bolt.
3. After conducting steps 1 and 2, measure toe-in. Toe-in should be .12 inch. If the left/right error is within specification but the overall toe-in is not, lengthen or shorten both arms in equal amounts by turning the two adjusting cams in opposite directions until the adjustment is not specification. Toe-in will change approximately .17 inch with each graduation of the adjusting cam (one side).