Distributor: Service and Repair

REMOVAL:

Spark Plug Removal/Installation:

1. Remove spark plug wires from spark plugs.

2. Disconnect distributor primary wire connector.

3. Remove distributor hold down bolts.

Distributor Removal And Installation:

4. Remove distributor from cylinder head.

INSTALLATION:

TDC Timing Marks:

1. Rotate the crankshaft clockwise to TDC. Position the slit of the exhaust camshaft.

Distributor O-ring Installation:

2. Apply a light coat of engine oil to the distributor O-ring prior to installation.

Distributor Drive Alignment:

3. Align the protrusion on the housing with groove of the coupling side.

Distributor Removal And Installation:

4. Install the distributor and align the protrusion of the flange with the nut of the valve cover.

Distributor Hold Down Bolts:

5. Lightly tighten the distributor hold down bolts.

6. Reconnect the distributor primary wire connector, distributor cap, and spark plug wires.

7. Adjust ignition timing. Refer to ADJUSTMENT PROCEDURES.