Ignition Control Module: Service and Repair

Distributor, Exploded View:

REMOVAL:

1. Remove distributor from vehicle refer to REMOVAL AND INSTALLATION.

2. Remove the distributor cap from the distributor.

3. Remove the ignition rotor, and dust covers.

Ignition Coil Primary Wire Installation:

4. Disconnect the wires from the terminals of the ignition coil.

Ignition Coil Removal:

5. Remove the four retaining screws. Remove ignition coil and dust proof packing.

Igniter Wires:

6. Remove the three screws and disconnect the three wires from the terminals of the igniter assembly.

Igniter Assembly Removal And Installation:

7. Remove the two igniter retaining screws, remove the igniter assembly from the distributor housing.

8. To install reverse removal procedures.